КАНАЛИЗАЦИОННАЯ НАСОСНАЯ УСТАНОВКА GRUNDFOS MSS.11.3.2 3x400V w/o NRV 97901061

  • Производитель: GRUNDFOS
  • Код товара: 97901061
  • КАНАЛИЗАЦИОННАЯ НАСОСНАЯ УСТАНОВКА GRUNDFOS MSS.11.3.2 3x400V w/o NRV 97901061
  • 0 р.

  • По запросу
Купить в 1 клик Скачать кп. в exel Нашли дешевле?
Наличие на 29.03.2024 :
Доставка в город:

До терминала ТК ......... Бесплатно
Срок доставки ..................... 3-14 д.
Гарантированно доставим
Подробнее о доставке

Supplied as complete unit ready for installation, the Multilift consist of a fully integrated collecting tank with pump and submersible motor, adapter for non-return valve, discharge adapter with flexible connection piece DN100 mounted on the collecting tank and a pre-wired Controller incl. a level sensor.

The fully integrated collecting tank has all necessary ports for the connection of inlet pipe in heights of 180mm and 250mm, vent pipe DN50 and a manually operated diaphragm pump (accessory).

The collecting tank contains 7 inlet sockets around it's shape. Back inlets 2x DN100 with one socket seal, socket for inlet at the sides 2 x DN100, top inlet DN100. 2x DN50 on top and side.

Multilift corrosion free polyethylen collecting tanks are gas- and odour-proof as well as watertight , reduction of residual water and less sedimentation by chamfered bottom design.

The pump with Vortex impeller and a maintenance free submersible motor, oil chamber with physiological harmless oil filling between two shaft seals. Motor protection via motor-protective circuit breaker inside pump head.

LC220 controller with microprocessor is equipped with LED for all monitoring necessities. The pump and sensor are connected to the controller with 4m or 10m cable and tube length. The power supply cable is 1,5m with plug (incl. phase inverter for 3 phase motor) Contactless, piezo resistive pressure sensor pluggable inside the cabinet, monitored by controller. Blockage free pressure tube inside the tank without movable parts inside wastewater.

The controller offer monitoring of pump operation.

Controller functions:

  • on/off control of one wastewater pump based on a continuous signal from a piezo-resistive sensor
  • dry running motor protection via run-time limitation with a following emergency operation
  • 24h automatic test runs during long periods of inactivity
  • operating indication:
  • pump status (running, fault)
  • time for service/maintenance once a year (selectable on/off by DIP switch)
  • fault indication:
  • phase-sequence fault and missing phase at 3ph. motors
  • high-water alarm
  • sensor fault
  • external alarm-switch (only alarm)
  • potential free contact for common alarm
  • automatic or manual alarm resetting (selectable by DIP switch)
  • easy selection of start level 180 or 250mm (selectable by DIP switch)

One additional input to connect a separate level switch to be used for flood detection outside the Multilift (external alarm). Lifting stations are often installed in a sump inside the basement at the lowest point in the building. In case of e.g. groundwater inflow or water pipe burst, an alarm will be indicated by the controller.

The Multilift range is designed due to the standard EN12050-1, approved and monitored by external institute LGA. Further approvals are VDE, GHOST, CB, EMV

РАБОЧИЕ ХАРАКТЕРИСТИКИ

Технические данные:
Тип рабочего колеса:  VORTEX
Максимальный размер частицы:  40 мм
CE approved (Yes/No):  Да
EN number for LGA approval:  Да
Тип клапана:  НЕТ

Материалы:
Корпус насоса:  Композит
Бак:  Полиэтилен пониженной плотности
Прокладка:  NBR

Жидкость:
Максимальная температура жидкости:  40 °C
Плотность:  998.2 кг/м³

Данные электрооборудования:
Потребляемая мощность - P1:  1.8 кВт
Номинальная мощность - P2:  1.1 кВт
Частота питающей сети:  50 Hz
Номинальное напряжение:  3 x 400 V
Допуст.откл-е напряж:  +10/-6 %
Макс. число пусков в час:  60
Номинальный ток:  3.1 A
Cos phi - коэф-нт мощности:  0,85
Номинальная скорость:  2785 об/м
Количество полюсов:  2
Способ запуска:  прямой пуск
Класс защиты (IEC 34-5):  IP68
Класс изоляции (IEC 85):  F
Тип кабельной вилки:  CEE3P+N+PE
Сетевой кабель:  1.5 м

Резервуар:
Общий объём резервуара(ов):  44 л
Общий эффективный объем бака с вх. отверстием 180мм:  20 л
Общий эффективный объем бака с вх. отверстием 250 мм:  28 л

Габаритный чертеж

Общее
Модельный ряд: MSS 11.3
Категория: КАНАЛИЗАЦИОННАЯ НАСОСНАЯ УСТАНОВКА
Группа: J4
Вес, кг.: 28.00
Программа поставки: GRU2018
Дополнительные характеристики
Номинальная скорость, об/мин.: 2785
Способ запуска: прямой пуск
Макс. гидростатический напор, м.: 11.8
Maкс. расход: 9.61 л/с
Номинальное напряжение: 3 x 400 V
Потребляемая мощность - P1: 1.8 кВт
Номинальная мощность - P2: 1.1 кВт
Номинальный ток: 3.1 A
Частота питающей сети: 50 Hz
Корпус насоса: Композит
Прокладка: NBR
Максимальная температура жидкости: 40 °C
Плотность: 998.2 кг/м³
Защита электродвигателя: KLIXON

Написать отзыв

Внимание: HTML не поддерживается! Используйте обычный текст!
    Плохо           Хорошо
Отправить заявку